Arctic Cooling ATI Silencer 1 ATI1 (9x00) Revision 1

The new Arctic Cooling ATi1 VGA Silencer combines very effective cooling with little noise.

The black intake fan sucks air inside the housing and pushes it across a radiator duct finally exhausting out the rear of the case chassis. The Graphics Processing Chipset is effectively cooled and the warm air from the VGA card is expelled from the case. This contributes to lower overall case temperatures by preventing warm air from being recycled.

As an overclocker the VGA Silencer is a proven performer, offering less or comparable noise while cooling substantially better than stock VGA coolers. The heatsink consists of aluminum fins with a copper base which guarantees excellent heat dissipation.

Suitable for:

ATI 9500 Pro, 9600 Pro/ XT, 9700 Pro, 9800 (with glued memory heat sinks)
Note: some models may not be supported. Please consult Arctic-Cooling to ensure compatability with your card.
You can find Arctic Cooling's compatability guide HERE
* PLEASE READ THE ARCTIC COOLING NOTE ABOUT ASUS VIDEO CARDS

Specifications:

Model: ATi1
Fan Speed: 2000 RPM
Connector Type: Small 2 pin ** see note below
Cable length: 170mm
Ram Cooling: No
RPM Monitoring: No

Features:

DHES - Direct Heat Exhaust system (exhausts hot air out of the case)
Long Life Ceramic Bearing Fan
Hair Dryer style exhaust channel with 23 fin radiator
2.5mm thick Copper Heatsink Plate

Note:

The New ATI 9800 Pro and 9600 boards use 3 pole power connectors. Since the third pole (RPM Signal) is of no significance nor can this signal be utilized by the graphic card, there is no disadvantage using the VGA Silencer. The 2 pole plug should be connected to the 3 pole connector, so that the black and red cables
are connected to the same pins as the case was before with the 3 pole connectors.

Arctic Cooling ATI Silencer 1 ATI1 (9x00) Revision 1